Water filter filtex ft 502

Filter properties

4-stage filter consisting of ceramic, carbon, cotton and stainless steel with antibacterial properties. Small and large suspended sediments help trap odor, color, chlorine and organic matter in the water. making the water after filtering more pure The average filter life is 1-3 months.
How to connect the adapter to the end of the tap

    Remove the valve head locking cap. out of the valve head to turn on-off the water
    Remove the original end of the tap. and choose an adapter that matches the end of the tap of the customer
    Attach the adapter to the valve head locking cap. and then screw the end of the adapter to the end of the customer's tap
    Screw the locking cap onto the water valve head.

How to connect the adapter rubber bushing to the end of the tap

    Remove the valve head locking cap from the water valve head.
    Insert the screw-in adapter followed by a screw cap to lock the valve head with a rubber bushing on top
    Connect the rubber bushing to the end of the tap of the customer. Tighten the belt to the end of the customer's tap.

How to connect the shoe set to the on-off valve head

    Open the cover above the filter unit. Remove the plastic seal covering the filter element from the filter element. and put it back into the filter head assembly.
    Put the filter head set into the valve head. Turn the water on-off horizontally, then twist the filter head up 90 degrees.

how to change the filter

    Turn the filter head down 90 degrees and pull it out of the valve head to turn on-off the water.
    Turn the cap on the top of the filter unit counterclockwise. and remove the old filling. Replace it with a new filter, remove the plastic cover. Turn the cover on the top of the filter assembly as before.
    Connect the filter to the valve head to turn on-off the water.

Caution

    The end of the drinking water tap should be cleaned every day. with clean water to avoid bacterial growth
    The filter should be cleaned weekly.
    Run the running water for 10 seconds before use each day.
    This product is suitable for water temperature 15-38 degrees, please do not install near open flame. or high temperature to avoid deformation or cracking may damage the filter.
    Do not place the water purifier in direct sunlight. It may deform and discolor.
    Tape should be applied to threaded connections. to prevent water leakage
    Should choose the adapter set that is suitable for the faucet of the customer.

Recommendations before using the product

    Tap water pressure must be between 1-2 bar. If you are using a water purifier with a pressure greater than 1-2 bar, open the tap slowly. or install a pressure reducing valve on the water inlet to avoid excessive pressure
    Before you install the water filter Make sure your existing adapter is suitable for installing your faucet.
    Choose the appropriate adapter in the kit to match the end of your faucet. In case the threaded adapter set does not fit the end of your faucet (Thread size mismatch) Use your tap end adapter rubber bushing instead of thread set. But the tap used must have a diameter of 15-24 mm only.

Recommendations for using a strainer at the end of the tap

    for maximum efficiency should be used with tap water sources and install away from heat, sunlight and damp areas.
    You should wash your hands before changing the filter every time.
    It should be used with normal water temperature 15-38 degrees.
    The water filter should be washed regularly. at least once a week
    The filter should be replaced with a new one. After using it for 1-3 months
    Suitable for use with tap water only.

How to maintain the filter

    If the filtered water starts to flow slowly Turn the cap on the top of the filter unit. Then bring the filter to scrub with sandpaper around the filter.
    Rinse again with clean water before putting the filter back in.